FOLLOW INSTRUCTIONS EXACTLY - USE THE COMB AS DIRECTED KEEP OFF THE SCALP
Hair Razor Treatment Steps –

1. comb moist hair straight - Apply small 4" strip of Step 1 across flat comb( off the edge as shown ). combing thru first 2 inches starting from just off the scalp, apply in 4"x4" sections. Starting at rear of head on one side, comb thru each section a couple times in all directions (Right to left, left to right, up and down), move to next section (apply product to comb for each section). work your way from back to front of head. do not over apply only need to coat the first 2” of hair, no massaging or working it in, no visible product, should only look shinny, leave in for 15 minutes from start of application . go to step 2 wash.
   
2. Apply small amount of the red Razor Wash shampoo, enough to wash thru first 2 ", wash and rinse out well. Does not sit . - long hair – to keep hair from tangling apply any type conditioner, rinse and comb straight with broad comb (if you run out of shampoo green PRELL is suggested )
   
3. Apply Step 2 (blue) Short hair - Apply in same manner as step one, only you will use broad side of comb so applied a little thicker ( contains sulfides so may foam if hair is on damp side ). leave in for 10 minutes. Rinse well ( no shampoo) . - Long Hair option- just enough step 2 with finger tips to work thru first 2" of damp hair and them comb thru as directed above.
   

Keep away from eyes - Do not use on eyebrows or eyelashes. Do not leave in longer than directions state. keep track of time. You may use any hair products you normally do. Do not use if scalp is irritated, sunburned, damaged or prior chemical treatments like relaxer perms or bleaching products have been recently used as will melt hair. Apply thin layer of Vaseline to hairline and cover shoulders with towel. If contact irritation / reaction occurs wash immediately with step 2 , discontinue use and consult us.

1.